INSTALLATION
PROCEDURE
1. INSTALL BACK DOOR LOCK ASSEMBLY
Click here
2. INSTALL BACK DOOR TRIM PANEL ASSEMBLY (w/o Rear No. 2 Seat)
Click here
3. INSTALL BACK DOOR TRIM PANEL ASSEMBLY (w/ Rear No. 2 Seat)
Click here
4. INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
Click here
5. INSTALL DOOR PULL HANDLE
Click here
6. INSTALL BACK DOOR TRIM BASE
Click here
7. INSTALL BACK DOOR LOCK COVER (w/o Rear No. 2 Seat)
Click here
8. INSTALL BACK DOOR LOCK COVER (w/ Rear No. 2 Seat)
Click here
9. INSTALL BACK DOOR TRIM COVER LH (w/o Rear No. 2 Seat)
Click here
10. INSTALL BACK DOOR TRIM COVER LH (w/ Rear No. 2 Seat)
Click here
11. INSTALL BACK DOOR TRIM COVER RH
HINT:
Use the same procedure as for the LH side.
12. INSTALL BACK WINDOW UPPER PANEL TRIM (w/o Rear No. 2 Seat)
Click here
13. INSTALL BACK WINDOW UPPER PANEL TRIM (w/ Rear No. 2 Seat)
Click here
14. INSPECT POWER BACK DOOR SYSTEM
Click here
15. INSPECT BACK DOOR CLOSER SYSTEM
Click here
InspectionLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Airbag Sensor(w/o Rear No. 2 Seat): Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear airbag sensor removal/installation are shown below. Necessary Procedure After Parts Removed/Insta ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Washer Level Warning Switch: Inspection
INSPECTION PROCEDURE 1. INSPECT LEVEL WARNING SWITCH ASSEMBLY HINT: This check should be performed with the level warning switch assembly installed on the washer jar. (a) Fill the washer jar with washer fluid. *a Component without harness connected (Level Warning Switch Assembly) ...