INSPECTION
PROCEDURE
1. INSPECT NO. 1 INTERIOR ILLUMINATION LIGHT ASSEMBLY
| (a) Inspect the No. 1 interior illumination light. (1) Apply battery voltage to each terminal of No. 1 interior illumination light connector and check the operation of the No. 1 interior illumination light. Result:
If the result is not as specified, replace the No. 1 interior illumination light assembly. |
|
Components
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Sfi System: Vehicle Speed Sensor "A" No Signal (P050031)
DESCRIPTION Vehicles, which are equipped with ABS (Anti-lock Brake System), detect the vehicle speed using the skid control ECU (brake actuator assembly) and speed sensor. The speed sensor monitors the wheel rotation speed and sends a signal to the skid control ECU. The skid control ECU converts the ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Roof Rack(w/o Rear No. 2 Seat): Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL NO. 2 ROOF CARRIER SEAL HINT: When installing the No. 2 roof carrier seal, heat the roof rack assembly using a heat light. Heating T ...