INSTALLATION
PROCEDURE
1. INSTALL GLOVE BOX LIGHT ASSEMBLY
(a) Turn the glove box light assembly as shown in the illustration to install it.
| Install in this Direction |
2. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
Click here
3. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
Click here
4. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
5. INSTALL COWL SIDE TRIM BOARD RH
HINT:
Use the same procedure as for the LH side.
Click here
6. INSTALL FRONT DOOR SCUFF PLATE RH
HINT:
Use the same procedure as for the LH side.
Click here
7. INSTALL INSTRUMENT PANEL GARNISH RH
Click here
InspectionLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Vehicle Stability Control System: Slip Indicator Light does not Come ON
DESCRIPTION The skid control ECU (brake actuator assembly) controls the slip indicator light in the combination meter assembly via CAN communication. CAUTION / NOTICE / HINT NOTICE: After replacing the skid control ECU (brake actuator assembly), perform "Calibration". Click here PROCEDURE 1. ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Navigation System: NTSC Disconnected (from Park Assist/Monitoring ECU) (B1535,C1622)
DESCRIPTION These DTCs are stored if the radio receiver assembly judges that the signals or signal lines between the rear television camera assembly and the multi-display assembly are not normal as a result of its self check. DTC No. Detection Item DTC Detection Condition Trouble Area B ...