CUSTOMIZE PARAMETERS
CUSTOMIZE HEADUP DISPLAY SYSTEM
(a) Customizing with the Techstream
(1) Connect the Techstream to the DLC3.
(2) Turn the engine switch on (IG).
(3) Turn the Techstream on.
(4) Enter the following menus: Customize Setting / Display.
(5) Select the setting by referring to the table below.
NOTICE:
Be sure to record the current value before customizing.
Display| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| Projection Adjustment (Tilt) | Headup display image calibration (Tilt calibration) | Default | 1000000:Clockwise (Hi),0100000:Clockwise (Mid),0010000:Clockwise (Lo),0001000:Default,0000100:Anti-Clockwise (Lo),0000010:Anti-Clockwise (Mid),0000001:Anti-Cloc**cut** | Headup display (Meter mirror sub-assembly) |
| Master Caution Display Function | Function to activate/deactivate the master warning light | ON | 0:OFF,1:ON | Headup display (Meter mirror sub-assembly) |
How To Proceed With Troubleshooting
Problem Symptoms TableLexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Charging System: Fail-safe Chart
FAIL-SAFE CHART If any of the following DTCs are stored, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily. Charging System DTC No. Fail-safe Operation Fail-safe Deactivation Condition P161A87 Generator command is fixed. Engine switch is turned on (IG) after ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Lighting System (w/ Automatic Headlight Beam Level Control System): Cornering Light Circuit
DESCRIPTION The No. 1 headlight ECU sub-assembly controls the cornering lights. WIRING DIAGRAM for Multiple Beam Headlight for Single Beam Headlight CAUTION / NOTICE / HINT NOTICE:
If the No. 1 headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle informati ...