PROBLEM SYMPTOMS TABLE
HINT:
| Symptom | Suspected Area | Link |
|---|---|---|
| Headup display is not displayed. | Fuse (ECU-DCC NO. 2, ECU-IG1 NO. 8) | - |
| Wire harness or connector | - | |
| Headup display switch assembly circuit | | |
| Headup display (Meter mirror sub-assembly) | | |
| Brightness of the headup display does not change. | Perform Active Test (Display Brightness) | |
| Read the Data List (Brightness Up Switch (Meter)), Brightness Down Switch (Meter)) | | |
| Headup display (Meter mirror sub-assembly) | | |
| Combination meter assembly | | |
| Headup display is not displayed in the correct position. | Perform Active Test (Display Position) | |
| Read the Data List (Projection Position Up Switch (Meter), Projection Position Down Switch (Meter)) | | |
| Headup display (Meter mirror sub-assembly) | | |
| Combination meter assembly | | |
| Other headup display malfunction (Other systems are normal) | Headup display (Meter mirror sub-assembly) | |
Customize Parameters
Terminals Of EcuLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Blind Spot Monitor System: Freeze Frame Data
FREEZE FRAME DATA FREEZE FRAME DATA (a) Whenever DTCs are detected, the blind spot monitor sensor stores the current vehicle (sensor) state as freeze frame data. CHECK FREEZE FRAME DATA (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the blind spot monitor system ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Seat Switch (for Rear No. 2 Seat): Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 1 FOLD SEAT SWITCH ASSEMBLY (for Rear Side) (a) Engage the 2 guides and 4 claws to install the No. 1 fold seat switch assembly as shown in the illustration. Install in this Direction 2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (for Rear Side) Click her ...