Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: Inspection

Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual / Vehicle Interior / Seat / Seat Heater Switch (for Rear Side) / Inspection

INSPECTION

PROCEDURE

1. INSPECT REFRESHING SEAT SWITCH (for Rear Side)

(a) Apply battery voltage and check the operation of the switch according to the table below.

OK:

Battery Connection

Condition

Specified Condition

Battery positive (+) → Terminal 7

Battery negative (-) → Terminal 9

Always

Illumination comes on

If the result is not as specified, replace the refreshing seat switch (for rear side).

*a

Component without harness connected

(Refreshing Seat Switch (for Rear Side))

2. INSPECT REAR SEAT HEATER SWITCH

(a) Apply battery voltage and check the operation of the switch according to the table below.

OK:

Battery Connection

Condition

Specified Condition

Battery positive (+) → Terminal 7

Battery negative (-) → Terminal 9

Always

Illumination comes on

If the result is not as specified, replace the rear seat heater switch.

*a

Component without harness connected

(Rear Seat Heater Switch)
    Components
    COMPONENTS ILLUSTRATION *A for Console Box - - *1 CONSOLE REAR END PANEL SUB-ASSEMBLY *2 REFRESHING SEAT SWITCH ILLUSTRATION *A for Armrest - - *1 ARMREST ASSEMB ...

    Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Meter / Gauge System: Odo/Trip Switch Malfunction
    DESCRIPTION In this circuit, the combination meter assembly detects ODO/TRIP switch signals via a direct line. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to anoth ...

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Steering Gear: Installation
    INSTALLATION PROCEDURE 1. INSTALL TIE ROD ASSEMBLY LH (a) Install the lock nut and tie rod assembly LH to the steering gear assembly until the matchmarks are aligned. HINT: After adjusting the toe-in, tighten the lock nut. *a Matchmark 2. INSTALL TIE ROD ASSEMBLY RH HINT: ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2026 Copyright www.lexusrx.net
    0.0097