Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: Removal

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear No. 3 speaker assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link

Disconnect cable from negative battery terminal

Memorize steering angle neutral point

Lane Control System

Pre-collision System

Intelligent Clearance Sonar System*1

Parking Assist Monitor System

Panoramic View Monitor System

Lighting System (w/ Automatic Headlight Beam Level Control System)

Initialize back door lock

Power Door Lock Control System

Reset back door close position

Power Back Door System (w/ Outside Door Control Switch)

*1: When performing learning using the Techstream.

Click here

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here

PROCEDURE

1. REMOVE TONNEAU COVER ASSEMBLY

Click here

2. REMOVE DECK BOARD ASSEMBLY

Click here

3. REMOVE REAR NO. 3 FLOOR BOARD

Click here

4. REMOVE REAR DECK FLOOR BOX

Click here

5. REMOVE REAR NO. 4 FLOOR BOARD

Click here

6. REMOVE FRONT DECK FLOOR BOX

Click here

7. REMOVE DECK SIDE TRIM BOX RH

Click here

8. REMOVE REAR FLOOR FINISH PLATE

Click here

9. REMOVE REAR DOOR SCUFF PLATE LH

Click here

10. REMOVE REAR SEAT ASSEMBLY LH

Click here

11. REMOVE UPPER QUARTER TRIM PAD LH

Click here

12. REMOVE REAR SEAT SIDE GARNISH LH

Click here

13. REMOVE REAR FLOOR FINISH SIDE PLATE LH

Click here

14. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

Click here

15. REMOVE ROPE HOOK ASSEMBLY

Click here

16. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY

Click here

17. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

Click here

18. REMOVE FUEL PUMP CONTROL ECU ASSEMBLY

Click here

19. REMOVE NO. 2 DECK BOARD REINFORCEMENT

(a) Remove the 2 bolts, nut and No. 2 deck board reinforcement.

20. REMOVE REAR NO. 1 SPEAKER BRACKET

(a) Remove the 2 nuts and rear No. 1 speaker bracket.

21. REMOVE REAR NO. 3 SPEAKER ASSEMBLY

NOTICE:

Do not touch the speaker cone.

(a) Disconnect the connector.

(b) Remove the 3 nuts and rear No. 3 speaker assembly.

    Components
    COMPONENTS ILLUSTRATION *A for TMC Made *B for TMMC Made *1 DECK BOARD ASSEMBLY *2 DECK SIDE TRIM BOX RH *3 FRONT DECK FLOOR BOX *4 REAR DECK FLOOR BOX *5 REAR FLOO ...

    Inspection
    INSPECTION PROCEDURE 1. INSPECT REAR NO. 3 SPEAKER ASSEMBLY (a) With the speaker installed, check that there is no looseness or other abnormalities. (b) Check that there is no foreign matter in the sp ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Can Communication System: Check Bus 3 Line for Short to +B
    DESCRIPTION There may be a short circuit between one of the CAN bus lines and +B when there is no resistance between terminal 6 (CA3H) of the network gateway ECU and terminal 16 (BAT) of the DLC3, or terminal 21 (CA3L) of the network gateway ECU and terminal 16 (BAT) of the DLC3. Symptom Troubl ...

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Headlight Assembly: Repair
    REPAIR CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. If the installation area of the headlight assembly is damaged, use a supply retainer for a low-cost repair. Ensure that the headlight assembly is not damaged. ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2026 Copyright www.lexusrx.net
    0.0097