CAUTION / NOTICE / HINT
HINT:
PROCEDURE
| 1. | VEHICLE BROUGHT TO WORKSHOP |
|
| 2. | CUSTOMER PROBLEM ANALYSIS |
(a) Confirm problem symptoms.
Click here
|
| 3. | CHECK CAN COMMUNICATION SYSTEM* |
(a) Using the Techstream, check if the CAN communication system is functioning normally.
OK:
CAN communication system is functioning normally.
HINT:
Click here
| NG | | GO TO CAN COMMUNICATION SYSTEM |
|
| 4. | SRS WARNING LIGHT CHECK |
(a) Proceed to Operation Check.
Click here
|
| 5. | CHECK FOR DTC* |
(a) Proceed to DTC Check / Clear.
Click here
OK:
DTCs are not output.
| NG | | GO TO STEP 12 |
|
| 6. | SYMPTOM SIMULATION |
(a) Proceed to How to Proceed with Troubleshooting.
Click here
|
| 7. | PROBLEM SYMPTOMS TABLE |
(a) Proceed to Problem Symptoms Table.
Click here
|
| 8. | CIRCUIT INSPECTION* |
|
| 9. | IDENTIFICATION OF PROBLEM |
|
| 10. | REPAIR OR REPLACEMENT |
|
| 11. | CONFIRMATION TEST |
| NEXT | | END |
| 12. | DIAGNOSTIC TROUBLE CODE CHART |
(a) Proceed to Diagnostic Trouble Code Chart.
Click here
|
| 13. | CIRCUIT INSPECTION* |
|
| 14. | IDENTIFICATION OF PROBLEM |
|
| 15. | REPAIR OR REPLACEMENT |
|
| 16. | CONFIRMATION TEST |
| NEXT | | END |
System Description
Operation CheckLexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Smart Access System With Push-button Start (for Entry Function): Open in Driver Side Electrical Antenna Circuit (B27A1)
DESCRIPTION The certification ECU (smart key ECU assembly) generates a request signal and transmits the signal to the front door outside handle assembly (for driver door) (electrical key antenna) at intervals of 0.25 seconds. For the front door outside handle assembly (for driver door) (electrical k ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Front Camera: Adjustment (sequential Recognition)
ADJUSTMENT (SEQUENTIAL RECOGNITION) CAUTION / NOTICE / HINT NOTICE: Make sure to read Before Starting Adjustment before proceeding with work. Click here PROCEDURE 1. SECURE APPROPRIATE AREA FOR PERFORMING LEARNING (a) Park the vehicle on a level surface. HINT:
Make sure that the target recog ...