DESCRIPTION
The airbag sensor assembly and occupant detection ECU communicate via CAN communication.
When the occupant detection ECU stores DTC B1771, B1780, B1782, B1795, B1798, B1799, U0125 or U0129, the airbag sensor assembly receives this information and stores DTC B1650.
When the occupant detection ECU stores DTC B1785 or B1787, the airbag sensor assembly receives this information and stores DTC B165A.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Test Mode / Check Mode |
|---|---|---|---|---|---|
| B1650 | Occupant Classification System Malfunction | The occupant detection ECU has stored DTC B1771, B1780, B1782, B1795, B1798, B1799, U0125 or U0129. | Occupant classification system | Comes on | Does not apply to test/check mode |
| B165A | Occupant Detection Sensor Zero Point Calibration Incomplete | The occupant detection ECU has stored DTC B1785 or B1787. | Occupant classification system | Comes on | Does not apply to test/check mode |
PROCEDURE
| 1. | CHECK DTC (OCCUPANT CLASSIFICATION SYSTEM) |
(a) Check for occupant classification system DTCs.
Click here
OK:
DTCs are not output.
| NG | | GO TO OCCUPANT CLASSIFICATION SYSTEM |
|
| 2. | CLEAR DTC (AIRBAG SYSTEM) |
(a) Turn the engine switch on (IG), and wait for at least 60 seconds.
(b) Clear the DTCs stored in memory.
Body Electrical > SRS Airbag > Clear DTCs| NEXT | | END |
Side Satellite Sensor Bus Lost Communication (LH) (B1647,B1648)
Driver Side Seat Position Sensor (B1653)Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Steering Pad Switch: Installation
INSTALLATION PROCEDURE 1. INSTALL STEERING PAD SWITCH ASSEMBLY (a) Engage the 2 claws and 2 pins to install the steering pad switch assembly. (b) Install the 2 screws. Torque: 2.4 N·m {24 kgf·cm, 21 in·lbf} (c) Connect the steering pad switch connector to the spiral cable with sensor sub-assembl ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Panoramic View Monitor System: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE:
The following inspection procedure of the panoramic view monitor system is described on the assumption that the navigation system*1 or audio and visual system*2 is normal. If the navigation system has any malfunction, first proceed with troubleshooting of the naviga ...