INSTALLATION
PROCEDURE
1. INSTALL RADIO RECEIVER ASSEMBLY
2. INSTALL NAVIGATION ECU (w/ Navigation ECU)
3. INSTALL NO. 2 RADIO BRACKET
(a) w/o Navigation ECU:
(1) Install the No. 2 radio bracket with the 3 screws.
(b) w/ Navigation ECU:
(1) Install the No. 2 radio bracket with the 5 screws.
(c) Engage the 2 clamps.
4. INSTALL NO. 1 RADIO BRACKET
(a) w/o Navigation ECU:
(1) Install the No. 1 radio bracket with the 3 screws.
(b) w/ Navigation ECU:
(1) Install the No. 1 radio bracket with the 5 screws.
5. INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY
(a) Engage the 4 claws to install the No. 3 instrument panel register assembly as shown in the illustration.
![]() | Install in this Direction |
6. INSTALL NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY
HINT:
Use the same procedure as for the No. 3 instrument panel register assembly.
7. INSTALL NO. 1 NAVIGATION WIRE (w/ Navigation ECU)
Click here
8. INSTALL CLOCK ASSEMBLY
Click here
9. INSTALL RADIO RECEIVER ASSEMBLY WITH REGISTER
(a) Connect each connector.
(b) Engage the 7 clips to temporarily install the radio receiver assembly with register as shown in the illustration.
![]() | Install in this Direction |
(c) Install the radio receiver assembly with register with the 2 bolts.
10. INSTALL LOWER INSTRUMENT FINISH PANEL SUB
Click here
11. INSTALL INSTRUMENT CLUSTER FINISH PANEL ORNAMENT
Click here
12. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
Click here
13. INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
Click here
14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
Lexus RX (RX 350L, RX450h) 2016-2022 Repair Manual > Oil Pump: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during engine unit removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/Rep ...
Lexus RX (RX 350L, RX450h) 2016-2022 Repair Manual > Vehicle Stability Control System: Slip Indicator Light Remains ON
DESCRIPTION This procedure is for troubleshooting when the slip indicator light remains on but no DTCs are output. The skid control ECU (brake actuator assembly) controls the slip indicator light in the combination meter assembly via CAN communication. The slip indicator light blinks during VSC and/ ...