DCM ACTIVATION
HINT:
If the DCM (telematics transceiver) has been replaced, it is necessary to perform the Register Vehicle Information procedure.
DCM ACTIVATION
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Choose "Telematics" from the System Selection Menu, and then click "Utility".
(e) Click "VIN Synchronization" on the Utility Selection Menu.
Body Electrical > Telematics > Utility| Tester Display |
|---|
| VIN Synchronization |
(f) According to the display on the Techstream, read the IMEI, ICCID, software version and VIN.
(g) Turn the engine switch off.
(h) Turn the engine switch to on (IG) and wait until only the manual (SOS) switch green indicator turns on.
HINT:
If only the manual (SOS) switch green indicator does not turn on even after 20 minutes elapse with the engine switch on (IG), refer to "GREEN INDICATOR REMAINS OFF".
Click here
Dcm Operation History
Acn Call EndLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Panoramic View Monitor System: "CHK" message(s) are displayed on the SIGNAL CHECK screen.
DESCRIPTION On the SIGNAL CHECK screen, it is possible to check if the signals sent to the parking assist ECU are normal. Click here HINT:
On the SIGNAL CHECK screen, "OK" (blue) is displayed for items with a normal inspection result or input state.
On the SIGNAL CHECK screen, "CHK" (red) is ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Headup Display System: Lost Communication with EMV (B1321)
DESCRIPTION After the headup display (meter mirror sub-assembly) has started, the headup display (meter mirror sub-assembly) attempts to detect the radio receiver assembly by performing communication via local bus. This DTC is stored when the radio receiver assembly has been detected but communicati ...