ACN CALL END
ACN CALL END
This function terminates the ACN (Automatic Collision Notification) to the telematics provider. After a collision in which the DCM receives "Collision Detection Signal", the vehicle will send the emergency call notification to the telematics provider until the emergency call cancellation utility has been run, or the mobilephone battery (if equipped) is depleted. Use the emergency call cancellation utility to stop the ACN call.
NOTICE:
The mobilephone battery must not be replaced while an ACN call is in progress.
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Choose "Telematics" from the System Selection Menu, and then click "Utility".
(e) Click "Emergency Call Cancellation " on the Utility Selection Menu.
Body Electrical > Telematics > Utility| Tester Display |
|---|
| Emergency Call Cancellation |
(f) Follow the instructions on the Techstream.
Dcm Activation
Customize ParametersLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Automatic Transaxle System: Transmission Fluid Temperature Sensor "A" Circuit Short to Battery or Open (P071015)
DESCRIPTION The ATF temperature sensor converts the automatic transaxle fluid (ATF) temperature into a resistance value for use by the ECM. The ECM applies voltage to the temperature sensor through terminal THO1 of the ECM. The sensor resistance changes with the ATF temperature. As the temperature r ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Axle Carrier (for 2wd): Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear axle carrier sub-assembly removal/installation are shown below. Necessary Procedures After Parts R ...