Lexus RX (RX 350L, RX450h) 2016-2022 Repair Manual: Customize Parameters

CUSTOMIZE PARAMETERS

CUSTOMIZE TELEMATICS SYSTEM

(a) Customizing with the Techstream.

NOTICE:

  • When the customer requests a change in a function, first make sure that the function can be customized.
  • Be sure to make a note of the current settings before customizing.
  • When troubleshooting a function, first make sure that the function is set to the default setting.

(1) Connect the Techstream to the DLC3.

(2) Turn the engine switch on (IG).

(3) Turn the Techstream on.

(4) Enter the following menus: Customize Setting / Others.

(5) Select the setting by referring to the table below.

Others

Tester Display

Description

Default

Setting

ECU

Telematics Microphone Volume Adjust

Sets the telephone microphone assembly volume

6

$01:1(MIN),$02:2,$03:3,$04:4,$05:5,$06:6,$07:7,$08:8,$09:9,$0A:10,$0B:11(MAX)

DCM (telematics transceiver)

Telematics Speaker Volume Adjust

Sets the telephone microphone assembly volume

8

$01:1(MIN),$02:2,$03:3,$04:4,$05:5,$06:6,$07:7,$08:8,$09:9,$0A:10,$0B:11,$0C:12,$0D:13,$0E:14(MAX)

DCM (telematics transceiver)

    Acn Call End
    ACN CALL END ACN CALL END This function terminates the ACN (Automatic Collision Notification) to the telematics provider. After a collision in which the DCM receives "Collision Detection Signal", the ...

    Initialization
    INITIALIZATION RESET BACK-UP BATTERY CONDITION HINT: If the back-up battery (mobilephone battery) has been replaced, it is necessary to perform the Reset Backup Battery Condition procedure. (a) Connec ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2022 Repair Manual > Radio Antenna Cord (w/ Rear No. 2 Seat): Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during antenna cord sub-assembly removal/installation are shown below. Necessary Procedures After Parts Remove ...

    Lexus RX (RX 350L, RX450h) 2016-2022 Repair Manual > Compressor: Installation
    INSTALLATION PROCEDURE 1. ADJUST COMPRESSOR OIL (a) When replacing the compressor and magnetic clutch with a new one: (1) Remove the drain bolt (seal washer) from a new compressor and magnetic clutch. *a Drain Bolt (Seal Washer) (2) Gradually discharge the inert gas fro ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2022 Copyright www.lexusrx.net
    0.0148