CALIBRATION
NOTICE:
When any of the following parts have been replaced, perform adjustment shown in the following table. If not, the intuitive parking assist system may not operate correctly.
ADJUST INTUITIVE PARKING ASSIST SYSTEM
(a) The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during intuitive parking assist system removal/installation are shown below.
| Part Name | Operation | Adjustment Item | Proceed to |
|---|---|---|---|
| Clearance warning ECU assembly | Replacement | Registration of bumper type | |
| Steering angle neutral point | |||
| Bumper type registration | |||
| Ultrasonic sensor detection angle registration | |||
| Ultrasonic sensor |
| Ultrasonic sensor detection angle | |
| Ultrasonic sensor detection angle registration | |||
| An ultrasonic sensor becomes misaligned | Ultrasonic sensor detection angle | ||
| Ultrasonic sensor detection angle registration | |||
| An ultrasonic sensor is subjected to impact | Ultrasonic sensor detection angle | ||
| Ultrasonic sensor detection angle registration |
Customize Parameters
Problem Symptoms TableLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Intuitive Parking Assist System (w/ Intelligent Clearance Sonar System): Control Module Communication Bus "A" Off (U0073,U0155)
DESCRIPTION These DTCs are stored when the clearance warning ECU assembly cannot receive and recognize several signals via the CAN communication line. DTC No. Detection Item DTC Detection Condition Trouble Area U0073 Control Module Communication Bus "A" Off Control module communicat ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Mirror Control System (w/ Memory): Power Retractable Mirrors do not Operate with Power Retract Mirror Switch
DESCRIPTION The multiplex network master switch assembly sends the retractable outer mirror switch signal to the main body ECU (multiplex network body ECU) via LIN communication. The main body ECU (multiplex network body ECU) then sends the mirror retract/return signal to each outer mirror control E ...