DESCRIPTION
These DTCs are stored when the clearance warning ECU assembly cannot receive and recognize several signals via the CAN communication line.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0073 | Control Module Communication Bus "A" Off | Control module communication bus off | CAN communication system |
| U0155 | Lost Communication with Instrument Panel Cluster (IPC) Control Module | Lost communication with the combination meter assembly | CAN communication system |
HINT:
When 2 or more DTCs starting with "U" are output simultaneously, inspect the connectors and wire harnesses of each ECU.
PROCEDURE
| 1. | CHECK DTC OUTPUT |
(a) Clear the DTCs
Click here
(b) Check for CAN communication system DTCs
Click here
| Result | Proceed to |
|---|---|
| CAN communication system DTCs are output | A |
| No CAN communication system DTCs are output | B |
| A | | GO TO CAN COMMUNICATION SYSTEM |
| B | | USE SIMULATION METHOD TO CHECK |
Rear Sensor Communication Malfunction (C1AED)
CAN Communication Failure (Message Registry) (U1000)Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Dynamic Torque Control Awd System: Linear Solenoid Circuit (C1298)
DESCRIPTION The 4WD ECU assembly receives signals from each sensor. The signals are used to control the clutch fluid pressure to vary the distribution of torque in accordance with the driving conditions. DTC No. Detection Item DTC Detection Condition Trouble Area C1298 Linear Solenoid ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Audio And Visual System (for 12.3 Inch Display): Reverse Signal Circuit between Radio Receiver Assembly and Navigation ECU
DESCRIPTION This circuit includes the navigation ECU and radio receiver assembly. WIRING DIAGRAM PROCEDURE 1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NAVIGATION ECU) (a) Disconnect the J149 radio receiver assembly connector. (b) Disconnect the J153 navigation ECU connector. ...