DESCRIPTION
These DTCs are stored when a malfunction occurs in the CAN communication circuit.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U014087 | Lost Communication with Body Control Module Missing Message | CAN reception error | CAN communication system |
| U015587 | Lost Communication with Instrument Panel Cluster (IPC) Control Module Missing Message | CAN reception error | CAN communication system |
| U016387 | Lost Communication with Navigation Control Module Missing Message | CAN reception error | CAN communication system |
PROCEDURE
| 1. | CHECK DTC |
(a) Clear the DTCs.
Body Electrical > Telematics > Clear DTCs(b) Recheck for DTCs and check if the same DTCs are output again.
Body Electrical > Telematics > Trouble Codes| Result | Proceed to |
|---|---|
| No DTCs are output. | A |
| DTCs are output. | B |
| A | | USE SIMULATION METHOD TO CHECK |
| B | | GO TO CAN COMMUNICATION SYSTEM |
Diagnostic Trouble Code Chart
Remote Engine Starter does not OperateLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Lumbar Switch: Installation
INSTALLATION CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL FRONT LUMBAR POWER SEAT SWITCH (a) Engage the 4 ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Sfi System: Fuel Rail Pressure Sensor "A" Circuit Short to Ground (P019011)
DESCRIPTION The fuel pressure sensor (for high pressure side) is installed on the fuel delivery pipe (for high pressure side). The fuel pressure sensor (for high pressure side) changes the fuel pressure for high pressure side into an electrical signal and sends the signal to the ECM. Then the ECM c ...