On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT BRAKE PEDAL SUPPORT ASSEMBLY
| (a) Make sure that there is no looseness in the locking part and the connecting part of the connector. |
|
(b) Disconnect the brake pedal load sensing switch (brake pedal support assembly) connector.
(c) Check both the connector case and the terminal for deformation and corrosion.
OK:
No deformation or corrosion.
NOTICE:
(d) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 (FSW+) - 1 (FSW-) | Brake pedal load sensing switch off (Brake pedal depressed) | 950 to 1050 Ω |
| 2 (FSW+) - 1 (FSW-) | Brake pedal load sensing switch on (Brake pedal released) | 203 to 223 Ω |
If the result is not as specified, replace the brake pedal load sensing switch (brake pedal support assembly).
Brake Hold SwitchLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Vehicle Stability Control System: Vehicle Control History
VEHICLE CONTROL HISTORY DESCRIPTION
Vehicle Control History is a function that captures and stores ECU data when triggered by specific vehicle behavior.
It may be possible to determine the cause of the malfunction by checking the vehicle history information and freeze frame data.
The number o ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Dynamic Torque Control Awd System: System Diagram
SYSTEM DIAGRAM Communication Table Transmitting ECU Receiving ECU Signal Communication Method
*1: w/ Optitron Meter Type
*2: w/ TFT Meter Type Skid control ECU (Brake actuator assembly) 4WD ECU assembly
Wheel speed sensor signal
Stop light switch signal
CAN communic ...