CAUTION / NOTICE / HINT
HINT:
*: Use the Techstream.
PROCEDURE
1. | VEHICLE BROUGHT TO WORKSHOP |
|
2. | CUSTOMER PROBLEM ANALYSIS |
(a) Interview the customer and confirm the problem.
Click here
|
3. | CHECK DTC AND FREEZE FRAME DATA* |
(a) Check and record DTCs and Freeze Frame Data.
for DTC Check / Clear: Click here
for Freeze Frame Data: Click here
(b) Clear the DTCs and Freeze Frame Data.
for DTC Check / Clear: Click here
for Freeze Frame Data: Click here
(c) Reconfirm the DTCs.
(1) Reconfirm the DTCs based on the recorded DTCs and Freeze Frame Data.
for DTC Check / Clear: Click here
for Freeze Frame Data: Click here
HINT:
Click here
Click here
Click here
C137BA2: Click here
C137BA3: Click here
Result | Proceed to |
---|---|
DTCs are output. | A |
DTCs are not output. (Problem symptom does not occur.) | B |
DTCs are not output. (Problem symptom occurs.) | C |
B | ![]() | GO TO STEP 5 |
C | ![]() | GO TO STEP 6 |
|
4. | DIAGNOSTIC TROUBLE CODE CHART |
(a) Proceed to Diagnostic Trouble Code Chart.
Click here
NEXT | ![]() | GO TO STEP 7 |
5. | SYMPTOM SIMULATION |
(a) Proceed to How to Proceed with Troubleshooting.
Click here
NEXT | ![]() | GO TO STEP 6 |
6. | PROBLEM SYMPTOMS TABLE |
(a) Proceed to Problem Symptoms Table.
Click here
|
7. | CIRCUIT INSPECTION* |
|
8. | IDENTIFICATION OF PROBLEM |
|
9. | REPAIR OR REPLACEMENT |
|
10. | RECONFIRM DTC* |
(a) Clear the DTCs.
Click here
(b) Check if the same DTCs are output.
Click here
Result | Proceed to |
---|---|
DTCs are not output. | A |
DTCs are output. | B |
B | ![]() | REPAIR CIRCUITS INDICATED BY OUTPUT DTCS |
|
11. | CONFIRMATION TEST* |
NEXT | ![]() | END |
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Maintenance: Under Hood
General MaintenanceGENERAL MAINTENANCE PROCEDURE 1. GENERAL NOTES
Maintenance requirements vary depending on country.
Check the maintenance schedule in the owner's manual.
Following the maintenance schedule is mandatory.
Determine the appropriate time to service the vehicle using either mil ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Radio Antenna Cord (w/o Rear No. 2 Seat): Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 4 ANTENNA CORD SUB-ASSEMBLY (a) Engage the 4 clamps to install the No. 4 antenna cord sub-assembly. (b) Connect the connector. 2. INSTALL BACK DOOR TRIM PANEL ASSEMBLY Click here 3. INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY Click here 4. INSTALL D ...