INSTALLATION
PROCEDURE
1. INSTALL YAW RATE SENSOR ASSEMBLY
(a) Install the yaw rate sensor assembly with the 2 bolts.
Torque:
14.5 N·m {148 kgf·cm, 11 ft·lbf}
NOTICE:
(b) Connect the connector to the yaw rate sensor assembly.
NOTICE:
Make sure that the yaw rate sensor assembly connector is connected securely.
2. INSTALL FRONT NO. 2 CONSOLE BOX INSERT
Click here
3. INSTALL CONSOLE BOX ASSEMBLY
Click here
4. PERFORM CALIBRATION
(a) When the yaw rate sensor assembly is replaced, perform calibration.
for VSC System: Click here
for Dynamic Torque Control AWD System: Click here
5. CHECK AND CLEAR DTC
Click here
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Sfi System: Lack of Power
DESCRIPTION Problem Symptom Suspected Area Trouble Area
Engine speed fluctuation due to abnormal combustion
Idle speed too low or high
Strong engine vibration due to above symptoms
Ignition malfunction
Deviation in air fuel ratio (Excessive or insufficient intake air volume ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Air Conditioning System: Air Conditioning Control Panel Circuit
DESCRIPTION The radio receiver assembly (A/C control panel) switch signals are sent to the air conditioning amplifier assembly via CAN communication. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this system before performing the following procedure. PROCE ...