Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT BRAKE BOOSTER ASSEMBLY

(a) Airtightness check

(1) Start the engine and stop it after 1 or 2 minutes. Slowly depress the brake pedal several times.

If the brake pedal can be depressed nearly to the floor the first time, but on the 2nd and 3rd time cannot be depressed as far, the brake booster assembly is airtight.

*a

Correct

*b

Incorrect

*c

1st

*d

2nd

*e

3rd

(2) Depress the brake pedal with the engine running, and stop the engine with the brake pedal depressed.

If there is no change in the brake pedal reserve distance while holding the brake pedal depressed for 30 seconds, the brake booster assembly is airtight.

(b) Operation check

(1) Depress the brake pedal several times with the ignition switch off and check that there is no change in the brake pedal reserve distance when the brake pedal is depressed.

(2) Depress and hold the brake pedal, then start the engine.

If the brake pedal goes down slightly, operation is normal.

    Components
    COMPONENTS ILLUSTRATION *1 COWL SIDE TRIM BOARD LH *2 FRONT DOOR SCUFF PLATE LH *3 NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY - - ILLUSTRATION *1 OUTER COWL TOP PANEL ...

    Disassembly
    DISASSEMBLY PROCEDURE 1. REMOVE BRAKE VACUUM CHECK VALVE ASSEMBLY (a) Remove the brake vacuum check valve assembly from the brake booster assembly. (b) Remove the check valve grommet from the brake bo ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Sfi System: Engine Coolant Temperature Sensor 1 Circuit Short to Ground (P011511)
    DESCRIPTION A thermistor, whose resistance value varies according to the engine coolant temperature, is built into the engine coolant temperature sensor. The structure of the sensor and its connection to the ECM are the same as those of the intake air temperature sensor. HINT: When DTC P011511 is st ...

    Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Combination Switch: Inspection
    INSPECTION PROCEDURE 1. INSPECT COMBINATION SWITCH ASSEMBLY (a) Inspect the NORMAL or NORMAL CUSTOMIZE mode switch: (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 8 (B) - 1 (GND) Combinati ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2026 Copyright www.lexusrx.net
    0.0099