INSPECTION
PROCEDURE
1. INSPECT FRONT DRIVE SHAFT ASSEMBLY
| (a) Check that there is no excessive play in the radial direction of the outboard joint. |
|
(b) Check that the inboard joint slides smoothly in the thrust direction.
(c) Check that there is no excessive play in the radial direction of the inboard joint.
(d) Check the boots for damage.
| (e) Check whether the dimension (A) of each drive shaft is within specification. NOTICE: Keep the drive shaft assembly level during inspection. Dimension (A) for TMC Made:
Dimension (A) for TMMC Made:
|
|
Removal
DisassemblyLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Lighting (ext): Relay
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT H-LP LH RELAY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 3 - 5 Voltage not applied between terminals 1 and 2 10 kΩ or ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Airbag System: Lost Communication with Front Door Pressure Sensor LH (B167B,B167C)
DESCRIPTION The side collision sensor LH circuit (bus 1) consists of the airbag sensor assembly, door side airbag sensor LH and rear airbag sensor LH. The door side airbag sensor LH and rear airbag sensor LH detect impacts to the vehicle and send signals to the airbag sensor assembly to determine if ...