ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY
(a) Connect the Techstream to the DLC3.
(b) Start the engine.
(c) Turn the Techstream on.
(d) Inspect the camshaft timing oil control solenoid assembly (for intake side).
(1) Enter the following menus: Powertrain / Engine / Active Test / Control the Intake VVT OCV Duty Ratio Bank 2 / Data List / Intake VVT Change Angle Bank 2.
Powertrain > Engine > Active Test Active Test Display |
---|
Control the Intake VVT OCV Duty Ratio Bank 2 |
Data List Display |
---|
Intake VVT Change Angle Bank 2 |
(2) Read the Data List while performing the Active Test with the engine idling.
OK:
Techstream Operation | Data List(Intake VVT Change Angle Bank 2) |
---|---|
-100% to 100% | Varies by 70 DegFR or more |
If the result is not as specified, check the camshaft timing oil control solenoid assembly, wire harness and ECM.
(e) Inspect the camshaft timing oil control solenoid assembly (for exhaust side).
(1) Enter the following menus: Powertrain / Engine / Active Test / Control the Exhaust VVT OCV Duty Ratio Bank 2 / Data List / Exhaust VVT Change Angle Bank 2.
Powertrain > Engine > Active Test Active Test Display |
---|
Control the Exhaust VVT OCV Duty Ratio Bank 2 |
Data List Display |
---|
Exhaust VVT Change Angle Bank 2 |
(2) Read the Data List while performing the Active Test with the engine idling.
OK:
Techstream Operation | Data List (Exhaust VVT Change Angle Bank 2) |
---|---|
-100% to 100% | Varies by 70 DegFR or more |
If the result is not as specified, check the camshaft timing oil control solenoid assembly, wire harness and ECM.
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Power Back Door System (w/ Outside Door Control Switch): Back Door Closer Operation Malfunction (B2250)
DESCRIPTION The multiplex network door ECU receives signals from the latch switch, position switch, pawl switch and back door courtesy switch, which are built into the back door lock assembly. Based on these signals, the latch position of the back door lock assembly is determined. DTC No. Detec ...
Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Seat Position Sensor: Installation
INSTALLATION PROCEDURE 1. INSTALL SEAT POSITION AIRBAG SENSOR (a) Engage the pin to install the seat position airbag sensor to the seat slide position sensor protector as shown in the illustration. (b) Using a 1.3 mm (0.0512 in.) feeler gauge, temporarily install the seat position ...