Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT CRUISE CONTROL MAIN SWITCH

(a) Measure the resistance according to the value(s) in the table below.

*a

Component without harness connected

(Cruise Control Switch)

-

-

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 (ECC) - 3 (CCS)

Cruise control switch (ON-OFF button) released

1 MΩ or higher

Cruise control switch (ON-OFF button) pushed

Below 2.5 Ω

+/RES

235 to 245 Ω

-/SET

617 to 643 Ω

CANCEL

1509 to 1571 Ω

(1) If the result is not as specified, replace the cruise control main switch.

    Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during crui ...

    Installation
    INSTALLATION PROCEDURE 1. INSTALL CRUISE CONTROL MAIN SWITCH (a) Connect the connector. (b) Pass the cruise control switch wire under the rib as shown in the illustration, and temporarily install t ...

    Other materials:

    Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Canister: Components
    COMPONENTS ILLUSTRATION *A w/o Rear No. 2 Seat *B w/ Rear No. 2 Seat *1 TAIL EXHAUST PIPE ASSEMBLY *2 EXHAUST PIPE GASKET *3 EXHAUST PIPE SUPPORT - - N*m (kgf*cm, ft.*lbf): Specified torque ● Non-reusable part ILLUSTRATION *1 CHARCOAL CANISTER PROT ...

    Lexus RX (RX 350L, RX450h) 2016-2025 Repair Manual > Sfi System: Catalyst System Efficiency Below Threshold Bank 1 (P042000,P043000)
    MONITOR DESCRIPTION The ECM uses sensors mounted in front of and behind the Three-Way Catalytic Converter (TWC) to monitor its efficiency. The first sensor, the air fuel ratio sensor, sends pre-catalyst information to the ECM. The second sensor, the heated oxygen sensor, sends post-catalyst informat ...

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Owners Manual

    Lexus RX (RX 350L, RX450h) 2016-{YEAR} Repair Manual

    © 2025 Copyright www.lexusrx.net
    0.0156