INSPECTION
PROCEDURE
1. INSPECT SKID CONTROL BUZZER ASSEMBLY
| (a) Make sure that there is no looseness in the locking part and connecting part of the connector. |
|
(b) Disconnect the skid control buzzer assembly connector.
(c) Check the connector and terminals for deformation and corrosion.
OK:
No deformation or corrosion.
(d) Connect a positive (+) lead from the battery to terminal 1, and a negative (-) lead to terminal 2 of the skid control buzzer assembly, and check that the buzzer sounds.
OK:
The skid control buzzer assembly sounds.
If the result is not as specified, replace the skid control buzzer assembly.
Removal
InstallationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Differential Mount Cushion: Replacement
REPLACEMENT CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear No. 2 differential mount cushion replacement are shown below. Necessary Procedures After Parts ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Mirror Control System (w/o Memory): Terminals Of Ecu
TERMINALS OF ECU CHECK OUTER MIRROR CONTROL ECU ASSEMBLY (DRIVER DOOR) (a) Disconnect the N4 outer mirror control ECU assembly (driver door) connector. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the con ...