DESCRIPTION
When each button displayed on the multi-display assembly is selected via remote touch screen operation, the remote touch screen generates vibration feedback according to communication between the remote touch (remote operation controller assembly) and radio receiver assembly.
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Click here
PROCEDURE
1. | CHECK MULTI-DISPLAY ASSEMBLY CUSTOMIZE SETTING |
(a) Check that the remote touch screen vibration feedback force customize setting is not set to "Off" on the multi-display assembly screen.
OK:
The remote touch screen vibration feedback force customize setting is not set to "Off".
NG | ![]() | CHANGE CUSTOMIZE SETTING |
|
2. | REMOTE TOUCH (REMOTE OPERATION CONTROLLER ASSEMBLY) SELF CHECK (CHECK VIBRATION FEEDBACK GENERATION CONDITION) |
(a) Enter self-diagnostic mode.
Click here
(b) Operate the remote touch screen laterally and check that the remote touch screen generates vibration feedback.
NOTICE:
Since the remote touch screen may recognize a pinch in/out or flick operation if operated with 2 fingers, always use 1 finger to operate the remote touch screen in self-diagnostic mode.
OK:
Remote touch screen generates vibration feedback.
NG | ![]() | REPLACE REMOTE TOUCH (REMOTE OPERATION CONTROLLER ASSEMBLY) |
|
3. | CHECK NAVIGATION ECU |
(a) Replace the navigation ECU with a new one.
Click here
(b) Check the malfunction disappears.
OK:
Malfunction disappears.
OK | ![]() | END (NAVIGATION ECU IS DEFECTIVE) |
NG | ![]() | REPLACE RADIO RECEIVER ASSEMBLY |
Lexus RX (RX 350L, RX450h) 2016-2023 Owners Manual > Bluetooth Phone: Speaking on the phone
The following screen is displayed when speaking on the phone.
To adjust the transmit volume
Select "Transmit Volume". To restore
default volume, move the controller to
the left on the "Transmit Volume"
screen and then select "Default".
To adjust in call volume
Move the controller to the lef ...
Lexus RX (RX 350L, RX450h) 2016-2023 Repair Manual > Driving Support Buzzer: Inspection
INSPECTION PROCEDURE 1. INSPECT SKID CONTROL BUZZER ASSEMBLY (a) Make sure that there is no looseness in the locking part and connecting part of the connector. (b) Disconnect the skid control buzzer assembly connector. (c) Check the connector and terminals for deformation and corrosio ...