INSPECTION
PROCEDURE
1. PRECAUTION
NOTICE:
After performing the following check, initialize the fold seat control ECU (initial position reset and initial position memorization).
Click here
2. INSPECT REAR SEATBACK FRAME SUB-ASSEMBLY RH
(a) Check the operation of the reclining motor.
(1) Apply battery voltage to the reclining motor connector, and check that the rear seatback frame sub-assembly RH operates smoothly as follows.
NOTICE:
| *1 | Fold Motor | *2 | Reclining Motor |
| *a | Forward | *b | Backward |
| *c | Component without wire harness connected (Rear Seatback Frame sub-assembly RH) | - | - |
OK:
| Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal x2-3 (FWD) Battery negative (-) → Terminal x2-4 (BACK) | Forward |
| Battery positive (+) → Terminal x1-1 Battery negative (-) → Terminal x1-2 | |
| Battery positive (+) → Terminal x2-4 (BACK) Battery negative (-) → Terminal x2-3 (FWD) | Backward |
| Battery positive (+) → Terminal x1-2 Battery negative (-) → Terminal x1-1 |
If the result is not as specified, replace the rear seatback frame sub-assembly RH.
Components
InstallationLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Differential Carrier Assembly: Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT NOTICE:
Before installation, thoroughly clean and dry each part and then apply Toyota Genuine Differential gear oil LT SAE 75W-85 GL-5 or equivalent to them.
Do not use alkaline cleaner for aluminum or rubber parts and rear differential case bolts.
Do not c ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Power Tilt And Power Telescopic Steering Column System: Tilt Position Sensor or Tilt Motor Circuit Malfunction (B2610)
DESCRIPTION The tilt motor is operated by the power source voltage supplied from the multiplex tilt and telescopic ECU and tilts the steering column up and down. The tilt position sensor (Hall IC) in the tilt motor detects the tilt angle of the steering column and sends a signal to the multiplex til ...