INSTALLATION
PROCEDURE
1. INSTALL RADIO SETTING CONDENSER
| (a) Engage the claw to install a new terminal cover to the wire harness. NOTICE:
|
|
| (b) Engage the 3 claws to install the new terminal cover with wire harness to a new condenser. NOTICE:
|
|
(c) Engage the clamp to temporarily install a new radio setting condenser with wire harness.
(d) Install the new radio setting condenser with the bolt.
Torque:
7.5 N·m {76 kgf·cm, 66 in·lbf}
2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH
Click here
3. INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
Click here
4. INSTALL ROPE HOOK ASSEMBLY
Click here
5. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
Click here
6. INSTALL REAR FLOOR FINISH SIDE PLATE LH
Click here
7. INSTALL REAR SEAT SIDE GARNISH LH
Click here
8. INSTALL UPPER QUARTER TRIM PAD LH
Click here
9. INSTALL REAR SEAT ASSEMBLY LH
Click here
10. INSTALL REAR DOOR SCUFF PLATE LH
Click here
11. INSTALL REAR FLOOR FINISH PLATE
Click here
12. INSTALL DECK SIDE TRIM BOX RH
Click here
13. INSTALL FRONT DECK FLOOR BOX
Click here
14. INSTALL REAR NO. 4 FLOOR BOARD
Click here
15. INSTALL REAR DECK FLOOR BOX
Click here
16. INSTALL REAR NO. 3 FLOOR BOARD
Click here
17. INSTALL DECK BOARD ASSEMBLY
Click here
18. INSTALL TONNEAU COVER ASSEMBLY
Click here
RemovalLexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Lane Control System: Parts Location
PARTS LOCATION ILLUSTRATION *1 MILLIMETER WAVE RADAR SENSOR ASSEMBLY *2 FORWARD RECOGNITION CAMERA *3 SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY) *4 ECM *5 POWER STEERING ECU ASSEMBLY - - ILLUSTRATION *A for TFT Meter Type *B for Optitron Meter Type *1 ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Airbag System: Short in P Squib Circuit (B1805-B1808)
DESCRIPTION The front passenger squib circuit consists of the airbag sensor assembly and instrument panel passenger airbag assembly. The airbag sensor assembly uses this circuit to deploy the airbag when deployment conditions are met. These DTCs are stored when a malfunction is detected in the front ...