DESCRIPTION
These DTCs are stored when a malfunction occurs in the navigation antenna assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B15C0 | GPS Antenna Connection Malfunction(short) | Navigation antenna assembly error |
|
| B15C1 | GPS Antenna Connection Malfunction(break) | Navigation antenna assembly power source malfunction |
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Click here
PROCEDURE
| 1. | CHECK DTC |
(a) Clear the DTCs.
Body Electrical > Navigation System > Clear DTCs(b) Recheck for DTCs and check that no DTCs are output.
Body Electrical > Navigation System > Trouble CodesOK:
No DTCs are output.
| NG | | USE SIMULATION METHOD TO CHECK |
|
| 2. | INSPECT ANTENNA CORD SUB-ASSEMBLY |
(a) Remove the antenna cord sub-assembly.
w/o Rear No. 2 Seat: Click here
w/ Rear No. 2 Seat: Click here
(b) Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected (Antenna Cord Sub-assembly) |
| *a | Component without harness connected (Antenna Cord Sub-assembly) |
Standard Resistance:
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A-3 - B-1 | Always | Below 1 Ω |
| A-3a - B-1a | Always | Below 1 Ω |
| A-3 or B-1 - Body ground | Always | 10 kΩ or higher |
| NG | | REPLACE ANTENNA CORD SUB-ASSEMBLY |
|
| 3. | INSPECT NAVIGATION ANTENNA ASSEMBLY |
(a) Remove the navigation antenna assembly.
Click here
(b) Inspect the navigation anenna assembly.
Click here
| OK | | REPLACE NAVIGATION ECU |
| NG | | REPLACE NAVIGATION ANTENNA ASSEMBLY |
Navigation Processor Malfunction (B15AD)
Speed Signal Malfunction (B15C2)Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Rear Power Seat Control System(for Second Row): Rear Power Seat Switch Circuit
DESCRIPTION HINT: The rear power seat switch is a collective term for the rear power seat switch RH and the rear power seat switch LH. When the rear power seat switch is operated, a recline signal is sent to the fold seat control ECU. The fold seat control ECU operates the reclining motor according ...
Lexus RX (RX 350L, RX450h) 2016-2026 Repair Manual > Oil Pump: Reassembly
REASSEMBLY PROCEDURE 1. INSTALL OIL PUMP ROTOR SET (a) Coat the drive rotor and driven rotor with engine oil and place them into the timing chain cover assembly with the rotor marks facing up. Check that the rotors rotate smoothly. *a Rotor Mark 2. INSTALL OIL PUMP COVER ...